Batmax USB-C LP-E6 LP-E6N LP-E6NH Dummy Battery Compatible with Canon EOS R, Ra, R3, R5, R5 C, R6, R7, R, 5D II/III/IV, 6D, 6D II, 7D, 7D II, 60D, 60Da, 70D, 80D, 90D, XC10, XC15, 5DS, 5DS R Cameras

Good item, Good price!

Did not work on a 6d Mark I. Tired multiple powebanks and wall chargers and camera would not power on. Took apart and tested the connections inside with voltmeter. Power is getting to the board inside, however not through it.

If you’re tired of trying to run things one battery at a time, but you aren’t quite ready for rails and a v-mount battery, this is your key to running off vastly cheaper USB-C power banks. Will you be able to make any given power bank work with it? That depends 100% on your setup. The details on power are in your manual, do the math and if your power bank can supply the correct wattage, you’re golden. (Your camera will think it’s plugged into AC, so don’t expect it to register the power bank’s charge.) OEM batteries are compact and fine out of the box, but particularly if you’re doing high bitrate video, you’re going to need more power than said batteries can supply. This gets it to you without going full-on v-mount.

It worked flawlessly in a Canon R6 MK II attached in a powerbank as well as in a standard charger. Great value for money! I didn't notice any restriction compared with standard batteries. It substitutes with good compatibility.

It’s perfecy

Will not power on a Canon Eos 80D. Tried 4 different usb-c ac adapters all ad different wattages and none of them worked. The cable is WAY too short if it even did work

Works fine with my Canon EOS R5. The cable is shorter than I expected. The image on the product page shows a 30cm straight section, an 80cm (when extended) coiled section and a 25cm straight section. It's actually 80cm (about 30") total length cable that is coiled in the center and it takes a fairly significant amount of force to stretch it. The force is enough to unplug the USB-C connector if its stretched to more than about 24" in length. You will probably need an extension cable. Make sure you have a charger/adapter that outputs 9V or 12V over USB-C.

I have been using something similar, which uses DTAP, then converts it to USB-C at the right voltage. This skips a step, so I can use just about any power bank with PD.