Oznium Brightest 2 Mile LED Boat Navigation Lights Pair. Flush Mount, USCG 112.5 Degree 2nm Boating nav Light for Pontoon Boat, Yacht, Kayak, air Boats, Marine. 1 Red Portside, 1 Green Starboard

Received this item for install onto a Gheenoe. Product is small but extremely bright! The housing is aluminum and robust, looks like it is very durable. I would have given this product 5 stars, but I had to drill two small holes for screws to be inserted in order to keep the lights from spinning when tightening. Overall I am extremely happy with the quality of this product.

These are even better quality in person than the pictures show. Fits flush with the hull of my kayak. Looks great. I put a dab of silicone underneath, just to help with waterproofing. Not sure that was even necessary it sits so flush and tight against the hull.To install just run the negative to the battery. Then run a positive to a on/off toggle switch, and then positive from the switch to the battery.(Excuse the catfish slime around the switch on my kayak's center console. Kayak is a Vibe Sea Ghost 130. Needed the navigation lights as I have a motor, and the law requires them on kayaks with motors.)One of the easiest mods I've done yet. Highly recommend this product.

This is somewhat of a mixed review. As for the quality of the product and overall looks, they are very good. Small, bright, and seem to be high quality metal and not cheap plastic. BUT, you need to be carful before you drill holes in your boat and pay very close attention to angles. I was going to mount these in the bow of my sailboat just below the rub rail, but as you can not adjust the forward angle, they can not be seen from the front as required (close, but not close enough). So while they look great, it doesn't meet the regulatory rules and unless the angle of your bow just happens to be perfect, I doubt they will meet both the forward view and side angle requirements. (As a suggestion, adding a pivot point and set screws so you can adjust the internal angle inside of the housing would be very helpful and solve most situations). I've also come across the international rules with respect to navigation lights that require that the sidelights be above the gunwale (basically deck level). So for inland lakes, this is a non issue, but if you plan on going to the ocean, it doesn't meet the rules. Short answer is I get to fix some holes in my sail boat and will have to return these. Again, good looking light and product, but look carefully at your mounting points/angles and read the rules before cutting any holes. Wish they would have worked as they look great.

Great product... Better than expected. Fast shipping.UPDATE: Lost an LED - the company shipped me another one, no questions asked. They were very pleasant! I am impressed by their customer service!I'll elaborate on these lights, since I'm so friggin' pleased- The housing is metal and feels great to the touch; it's clear the machining is high quality. The LED's are sealed and impervious. They mount easily. They look great. When I bought them I had no idea who the manufacturer/company was... I was a bit leery. Not now!

Fit and size are great... I have a concern with them not having a cover over the lens.. But they look and work great..

These are a great addition to any boat that you want to add some extra light to on the water. I prefer not to use the pole mounted or center mounted nav lights so I purchased these and have had them almost a year without any problems. Hope you don’t mind cutting holes into your boat because you will have to to install these

Things I like about them are the aluminum housing, flat mounting surface, two threaded collars to hold them on so no tools required and there's a few feet of wire so should work for almost any setup. They mark them with a piece of red or green heat shrink which is nice because with them being LED you have to power them to see the colors.

The LED navigation lights showed up on time and were very easy to install. I would highly recommend these light to friends and family and will purchase them again when the need arises.