3D Printer Build Surface 220x220 mm Magnetic Bed for Anet A8 WanHao i3 Anti-warping Detachable Square Black Eewolf

Fitted perfect first print stuck perfectly and ever since I'm going bye more

Works brill for a while, started peeling off the top layer sticker eventually after like a week and a half of use, still running it with the missing chunks just leaves a small bulge where the sticker has gone, would love to just buy the top sheet of the pair as it works great just needs replacing

I’ve spent months of experimenting with different build surfaces and everyone rated glass which was ok but even that wasn’t great. Tried tape, glue you name it I had tried it. However the product is GREAT. It’s sticks so well it’s almost too well and managed to drop my bed temp to 45 and still sticks great.Removing straight ofter printing is best as it comes off easier.Only one word of warning and this is not the products fault. Do not let your hot hotend crash into the bed or you will burn a small hole in the surface while hot and under the pressure from the stepper motors.I have printed 100 times or more since I got this and I get a perfect print every time with NO cleanup in between. Until now I’ve never been able to press print and walk away without baby sitting the first few layers looking for lifting etcSimply AwesomeUpdate.... still amazing, peal off print, scrape off brim, print and print and print away. Occasionally clean with meths to remove finger oils, which might affect adhesion, but I’ve not had a single failed print in 6 months

I used this on my printer and didn't have any luck with it.Installing it was easy enough with the base having great adhesion to the heatbed. The magnetic print bed was also easy to install and remove.Due to both parts being magnetic, i found it was quite thick and so took a while to heat up. The print bed itself didn't offer any adhesion on it's own so needed additional work to get prints to stick.I decided to remove it in the end which took a lot of work as it was so stuck on and the adhesive residue was left everywhere.in the end i changed to a removable glass bed which has been excellent and i've had much better results.

This is a must buy if you have a 3d printer I'm an architect students so I'm constantly printing models and befor I had to scrape them off the plate and sometimes the models would brake but with this build plate life is so much easier literally wait for it to cool down once it's done you take off the plate and bend and it's off easy as that doesn't even take a minute

absolutely first class adhesion. slightly difficult to remove at times depending on the model. need to let it cool down to take off.

I don’t often leave reviews, but this is the best £15 I’ve spent since having my 3D printer. I’ve had issues in the past with adhesion, warping and wasted so much filament I hate to think how much I’ve spent!!Not to mention the amount of blue tape I’ve used and hairspray / glue, etc.However, since installing this on my printer (Wanhao v2) every print has been spot on and getting prints off the bed is a breeze!Wish I’d bought one months ago!

Really happy with this, it sticks perfectly onto the labists ET4 bed. The matt sticks really well and the top surface stays on no problem. Had no issues with levelling and the prints adhere really well. So much easier to remove a print at the end.