LUBAN Industrial Warning Light, CNC Machine Warning Light with Rotating Base, 3-Stage Signal Column with Continuous/Flashing Light, Red Yellow Green Signal Light 110 V 220 V (without Buzzer)

It is difficult to see the lamps in daylight. They are ok in the dark.

There was nothing I didn't like about this unit. Once we figured out how to get it apart, the Green didn't budge but we managed to get a flat blade screw driver inside to change the switch from flash to constant. Then everything was fine. Like with all buzzers we had to put tape over the hols to quieten it down. I machined a dent into the base as I was passing the wires through the side not the bottom, no big chore. But now when the machine comes on it lights up green, when the Laser armed the Red light fires up and when there's an anomaly needed attending the orange/amber light flashes and the buzzer sounds. Solid bit of kit and should last for years. Oh and the wiring flummoxed me as the only diagram is on the side of the lamp, no other instructions but when adding it to the Rueda controller wiring diagram it made no sense to my brain, but my partner insisted that was correct way to go, I went for it closed my eyes and hit the power and low and behold it worked so I need to understand my Rueda controller really... lol Josh

Die Ware kam zum angekündigten Zeitpunkt. Die Funktion ist wie beschrieben.

Eingesetzt ein einem Zugangssystem erfüllt die Ampel alle Voraussetzungen: Leuchtet hell, der Alarmton ist weit zu hören, abklappbar und stabil. Kann via Relais mit GPIOs vom Raspi angesteuert werden

Works great, used it on a machine to indicate different states. The buzzer is not consistent though and is on a few second timer. Not sure if this was in the description but might be good to know.