MIG Welding Gun 100A 8-ft, Replacement Compatible with Chicago Electric Welder Parts Stinger Welder 130EN 160EN 180EN Fit for Craftsman 20569 20504

Easy to install and worked perfectly! The gas hose is a little short so make sure to route it correctly so it’ll reach the connection. Other than that no complaints. This replacement saved my welder from going to the trash.

Just got the welding gun today and hooked it up. The installation was ok. The gas hose is a little short. The gun itself I think is a little to long but ok. Inside the gun is a long metal peice that makes contact with a small push on connector that I think is cheap but works. Overall it is a nice gun and works well.

I bought this for my Craftsman mig welder model 20559. The installation was simple the I cut the connectors from the old part and used a heat shrink connector to splice them together. The gas line was a little short so I cut back some sheathing to extend the line further into the unit. After the installation it worked like a charm.

Installed on my ol' faithful craftsman, sure it looks cheap but works better than the original

I purchased this for a Craftsman Professional 120 MIG manufactured in 2002 and it works. Perhaps for the price, that should be good enough and worth an extra star but I wish I had spent a little more and got something a bit better. For starters, the gas hose is absolutely too short so any way you run it, there will be constant tension on the hose which will likely lead to eventual failure. It also makes it very difficult to install as you're stretching the hose while bending the back of the welder to take pressure off the fitting and hose. The trigger wires are bare ends, so plan to do some splicing or find connectors that fit your existing machine. Additionally the welding wire liner is way too long (on the Craftsman unit), so plan to carefully trim about 6 or so inches. I understand it's a universal gun but some simple connectors and a 1/2 inch more of gas tubing would have gone a long way.Ultimately, it's installed and works very well but it's far from plug & play and I question its longevity. If you need an inexpensive fix and are willing to spend some time on the install, this will work for you. When it eventually fails, I'll spend more for an upgraded unit or just replace the liner on my original gun and get another 20 years out of it.

This was a perfect fit for my Clarke 130EN Gas/No Gas MIG welder! I have absolutely no complaints whatsoever! Works every time and even came with a tip already installed! I would definitely recommend this product!

Gas hose is a little too short but it works

Had to modify stinger to operat on my old Lincoln welder