Deckhand 40 Anchoring System

I was tired of manually pulling and dropping the anchor on my 15' boat. Since I anchor to fly fish and move a lot, the Deckhand allows me to reposition or move with little effort. I am using a 20# river anchor and the winch has no trouble with spooling in or out. With a mounting plate it is easy to remove and install on the bow for trailering. I bought the remote switch for convenience to raise and lower the anchor from the console. Running off a 100AH battery, the winch can raise and lower a 20# anchor more than a 100 times in 50' of water. I am very pleased with the construction and ease of installation. Installation on the bow platform using a mounting plate plus wiring the power supply and remote took only about 3 hours.

Works great, very strong winch, will pull 28lb anchor out of thick river mud with ease!! Really appreciate not having to pull the anchor by hand. I switched to a 28lb anchor and it grabs great in swift current and I don’t have to jump up to pull the anchor. I think it’s a great safety feature as well. Planning to add on on the rear of the boat for sideways fishing.

I have two of these on my lake boat, forward and aft. I fish in lakes that can be quite deep and manual anchor deployment and retrieval is out of the question. These wenches take all of the work out of it and allow me to move around and re-anchor with little effort. No issues with operation so far. Installation was a bit of a chore but nothing that a handy DIYer can't handle.

Get the remote switch with it! Easy to use. I have 2, one for the front and one for the back. I run a 25# Pyramid off the front and a 20# pyramid off the back. Keeps my 16 ft Princecraft in the position perfectly.

I installed the MinnKota Deckhand 40 on my Tracker ProGuide V175 with remote switch and 30lb anchor. This gives me an extra option over the position (anchor) lock I have with my trolling motor and a ProNav setup. The ProNav is great but if you really want to hold a position in wind and waves you need a real anchor. I have a bad shoulder so I needed something that would deploy and retrieve at a touch of a button. The installation was challenging but not the fault of the winch itself. The deck at the bow of my boat has limited room and I had to build a platform for the winch. This required me to move my navigation light and remove a cup-holder and tool caddy (never used them anyway). Since removing these items from the deck left large holes I added an aluminum plate under the deck for added strength. Otherwise, the winch would have just been mounted to marine grade plywood and I wasn't sure the deck would hold up to the repeated stress. I found it easier to remove the cover and motor assembly from the frame for the install. This required unplugging the wires for the load sensing switch and the motor. I removed the motor from the unit which can be done by removing a c-clip and carefully rotating the motor assembly out of the unit. Just be sure not to lose the spring and plastic block at the end of the motor shaft. These parts act as part of the load sensing mechanism in conjuction with the switch. After the removal of the cover and motor you will have complete access to the mounting plate and holes for drilling and mounting the plate. Re-assembly was quite easy. The connectors on the circuit board are marked M+ and M- for proper orientation of the motor wires. The switch wires can be put on either way. The hardest part was getting the motor positioned properly to slide back into the frame. After the motor is in place you can re-install the spring, block, and c-clip. Re-attach the wires and cover and you are good to go. The main electrical connection wires are quite short. I was able to splice these directly into the trolling motor power as both would not be used at the same time. If your power source (battery) is not within a few feet plan on picking up some heavy gauge wire and good splice connectors. If you are not comfortable with altering and drilling holes in your boat and making electrical connections / splices I would suggest you have the winch installed by someone who is. Overall I am very satisfied with my purchase and I am considering a second winch for the aft of my boat.