PLEXICLICK® 4x Number Plate Holder - Black - Frameless Number Plate Clips For Acrylic UK Number Plates - Universal Reg Plate Holder - Strong & Secure License Plate Holder - 100% Made In Germany

Second set of these I have purchased, do a great job and look really cool

Perfect solution - my 4D number plates couldn’t be drilled and the old number plate was originally on my grill with no flat plate to mount using sticky pads, wanted an invisible solution that was secure. These do exactly that! Took less than 10 minutes to fit, super secure and unable to slide to side even if pushed hard ! No worry of someone stealing the plates as it’s quite tough to remove unless know how to do it. Clear instructions on fitting and removing. Universal hole positions which is handy. The screws supplied were too short for my car but was able to use the screws that came with original number plate.

I was sceptical but these are great plate holders. Comes with strong self drilling and tapping screws (I did drill a tiny pilot hole as I wanted to be sure the screws wouldn't walk sideways and move the hole location). The plates clip in really easily and are a bit more difficult to remove (which I like as it makes it slighly harder for people to steal your plates). They are also near invisible and give the plate a floating look. Tip: to remove the plates push the plate against the clip (this spreads the jaws slightly) then without removing the pressure, either press the top jaw up or bottom jaw down, the pressed jaw should release that part of the plate, then do the same to the other clip and slide the plate out.

Brilliant- invisible and really sturdy. Great for holding show plates for easy transfer of plates. Took 5mins to install

Great product if you want a frameless, minimalist look for your number plate. It fits standard 3mm UK acrylic plates perfectly and feels secure even at motorway speeds. Installation was straightforward with clear instructions and all the hardware included. Just be prepared to drill into the bumper if there are no existing holes. Overall, very happy with the look and function!

Great product and so easy to install. Plates look flawless without the need for sticky pads

My plate kept falling off and didnt like the look of screws, this has sorted it perfectly with no issues at all! The plate is hard to take off once its clipped in but beside from that its all good!

It is so simple it makes number plates easy as eating apple pie. A little bit of careful planning and it was easy enough to fit. Well done almost - unfortunately when I secured the screws using a medium medium locking glue. I fought that the base plastic cracked and meant I had to strart all over again- Fix by putting hole drill size and advise your clients to over tighten screws. Thank you