Digital Multimeter, Auto Ranging Pocket Digital Multimeter Digital Multi Tester - AC DC Voltage DC Current Resistance Diodes Capacitance Transistor Measuring Instrument (VC921)

I was initially going to return this because the size of product in photo appeared to be larger and robust. However I decided to keep it. Cons: Test lead wires are thin gauge. I probably wouldn’t use this on higher voltages. The meter isn’t very rugged. Wouldn’t use if I were a professional. Pros: It seems to work. Because it is smaller in size and thin when compared to better higher cost meters, l decided to keep in my office desk drawer and use it when working on simple repair and other projects from time to time.

Great meter for home use. Easy to use. Turns itself off. Has tone for ohm connection when chasing dc current. Storage for probes is nice and the tips are sharp for probing thru insulation on wires. And its about the size of a cellphone. The screen is easily visable and you can change the decimal. Amps, MA etc.

I bought this (Zotek) Digital Multimeter to replace a RS (brand name abbreviation) multimeter that I can no longer find to purchase. It is about the same size as my RS meter, but instead of opening like a book this one has a cover that hinges at the top of the meter and flips fully over. You really can't use it as a stand, since it won't support the meter without folding up, but it does sit well on a table with the cover opened all the way. To close the cover, the selection dial has to be set to the left (there are two "OFF" positions) "OFF" position before the cover will fully close. It says it is a "True RMS" meter, which I like. It has 'auto range' but you can manually change the range too! It has all the features, in a small meter, I was looking for....DC Voltage (600V max), AC Voltage (600 V max), Ohms resistance, Diode testing, Continuity testing, Capacitance testing, and Frequency/Duty Cycle (I don't use or need this one too much). Auto off was a big plus too! It turns itself off after 15 mins. of non-use and the feature itself can be turned off if needed! It uses 2-AAA batteries that are under a panel, with a screw, on the bottom/back of the unit. The test leads secure in the side pocket by flipping a little door up (to release them) and down (to store them)...It seems just like what I needed for around the home to replace my RS meter. Nice size to hold in your hand when working. Seems to be fairly accurate (within one to two volts of my other meter). It has a "one year warranty" that comes with it and even says so on the box and in the small instruction folder included (along with a hand strap). The only problem with this is that it gives NO CONTACT INFORMATION if you do have a problem with it! There is no company name on the box! There is no contact information whatsoever for questions or warranty concerning this meter! (It does say on the box "Made in China", so that will give me a starting point!) Once past the 30 day Amazon return window.....the unit is all yours, even with a one year warranty! I'll keep my fingers crossed that I have no problems with it! Otherwise, I'm happy, at this point, with the device!

I bought this to throw in the glovebox of my car for use on days I am not close to my fancier pocket meter (the Amprobe PM55A). This is more basic than the Amprobe - and much cheaper - but appears to be the same meter I have bought under a few more 'brand' names that I give out to grandkids, friends, etc.. to learn about electricity. So, I was familiar with the user interface. This seems to be a good replacement for use as a hand it out, leave it laying around meter - so I'll likely buy a few more. A step up from the free ones from harbor freight and you can't lose the probes (but can't swap them out either!) A good starter multimeter if it holds up like the ones I bought before.

Good bang for the buck, this is not a high end test meter so my expectations was not very high, I have had this for a few months and primarily use this for checking dc voltage and continuity for my Ham radio gear mostly but have used for ac as well around the house and tracing power problems on the Vehicle as well. Over all my expectations I was very pleased and impressed, very handy and small enough to toss in my tool kit and its plenty loud for checking continuity that makes it a big plus for my older ears. Used to be an industrial Electrician and never would use a meter like this for that type of work, how ever for light use around the house and vehicle it gets the job done very well for me.

I’m sure it’s a good meter, but the leads are terrible. I have to put my own leads on it. They’re not removable either so I will have to cut them or take the meter apart and unsaddle them. The leads are very short and stiff. Plastic insulating material is not the best. The meter itself seems to be pretty good and I like the form factor. I just wish they would’ve used silicone insulation on the wiring of the leads.

Perfect multimeter for the weekend warrior. I've used this multimeter to test spark plugs, alternators and a slew of other automotive tasks i've found myself a part of. Its honestly the perfect size for a go-bag and even your pocket! Get this one.

Works great! As other reviews mention, the leads and probes can be finnicky to stow, but definitely not a deal breaker given the price value to have this as spare in a glovebox or tool kit. If looking for a frequent use daily driver, definitely go for full size and probe ports. Also figured out trick to make it fold as stand: Open and run wrist strap THOUGH the slot in cover, then loop over bottom of cover. Hold it upright just fine. Only demoted 1 star for the stowing of probes challenge. Definitely recommended for compact portability.

Rubbish don't buy

I don't need any gorgeous tester. Just leave this tiny multimeter in my truck's glove box for emergency.

9990mfd condenser is correct value meserment

Perfect for basic testing and easy to use. I gave it a 4 star rating only because the cover that flips open as a stand kept sliding and fell. I fixed this problem by attaching rubber to the edges. I used double sided tape for this but glue could also be used with a thin strip of rubber, foam or neoprene.

Folding back of test wires inside is not easy. Wire looks like low quality. Display screen must have backlight.