GEARit Speaker Wire 14 Gauge 100 ft, UL CL3 Rated 14 Gauge Wire Copper Wire with Polarity Mark, Audio Cable for in-Wall, Home, Car,Outdoor, Garden, Commercial Audio Systems, OFC (Black,2-Conductors)

Good wiee. Be suee to get ofc and not the cca. Much better conduction and quality. Good price too.

This high quality cable was exactly what I needed. I purchased a moderately expensive low voltage lighting set that came with generic 14AWG direct burial cable. That would have been fine, but I needed to mount the transformer inside my basement, and since the cable passes into the interior of the house, it needs to pass the CL3 requirements for fire resistance. I contacted GearIT's Customer Service Department just to be sure the cable met the fire safety requirements, and also that it can be used for low voltage lighting (it's called speaker wire). The rep responded to my email immediately and cited the fire rating standards and confirmed the suitability for 12V landscape lighting and interior pass-through. She even gave me a few additional cautions about making sure I don't exceed a 15 amp load (transformer is 10 amp so I'm good on that), and also took the time to comment on my overall plan in terms of the number of cable runs and their length (which could cause voltage drop if they were too long). The cable arrived quickly and appears to be very high quality, with CL3 markings on the jacket and a small spec sheet showing the CL3 rating. Some people comment about the cable being too tightly coiled when it is removed from the spool, but I didn't encounter that issue at all. I'm really impressed with the GearIT product, and their Customer Service Department is one of the best I have ever dealt with!

This is some awesome cable. Full copper, thick but pliable outer jacket and the single pair insulation is almost comparable to MTW. My only criticism, is the linear foot increments printed on the outer jacket starts at 100 feet. Like many other wire mfrs, typically the tag end starts at 1’. Doesn’t bother me as I’m going to pull what I need regardless plus some, but for some it may be useful to have your spools start at 1’. Im only sending 30w RMS through this 14-2 down a 70’ run between active outdoor speakers without a hiccup. I would recommend their product to everyone. Worth the little extra cost for sure.

Great wire, cutting the sheathing without nicking the wire is tricky.. Just don't score it to deep, bend back and forth a little, then pull on the sheathing..

This is an extremely well made speaker cable. The outer jacket is very durable but flexible, making it easy to route through and around installation obstacles. It’s also very cleanly finished, any visibly exposed sections in your installation will look professional and polished. The inner signal transfer cables are also high quality and work well with binding posts or separate banana plugs- the copper core is tight and resists fraying and splintering. I fully expect this cabling to outlast my current equipment and be installed again on future gear.

I bought a couple of 14 gauge 100ft reels to setup speakers in the backyard. I hanged two speakers and extended the wires over 50ft distance in the air. The wires were quite sturdy, even with lots of tension to keep them straight across this long distance. The plastic casing is thick and strong.For the other 2 speakers, I buried the wires in the ground. That was quite easy due to the plastic enclosure. the 2 speakers had a whole 100ft wire length. But the speakers sounded great. Much better than expected.Unfortunately, I ran out of wire before setting the last speaker. So, just ordered one more for that.It's my first time to buy GearIt cables. But won't be the last for sure.

Excellent product and quality, easy to install and was as expected.

Great product

Great cable. Fast delivery. What more could you ask for?

Good quality cables. Will definitely get more of these in the future.

Great quality product !

Muy buena calidad

CL3 direct burial rated, OFC, excellent sheating, UL approved, true 14awg wire. Cutting through the outer sheathing to get to the red and black wires is bit tricky or you will cut the sheating on the copper wire. I used and exacto blade placed it between the red and black wire and slowly sliced through the middle separating as I was going along. Overall excellent quality and no sound degradation at a 50 feet run to each speaker. This can be used for low voltage lighting as well.