DEWALT Drill Flip Drive Kit (DW2702), yellow

Great accessory tool

Time saving drive and you don't have to carry more items.

An actual time-saving device! Enables quick swap of countersink and screwdriver bits, especially handy for work that is already off the work bench [for me so far, this includes cabinet ledgers, shelf supports, door hinges, etc.] It comes with a custom DeWalt countersink bit [replaceable $7USD] and a short Phillips head screwdriver bit with a standard hex [replaceable $5USD a dozen]. They are holding up just fine, but I'd recommend not storing this tool with the countersink bit exposed, you could break it off. The quick release is a bit counter-intuitive, as it releases in the opposite direction that I thought it would. There is no ability to modify the maximum depth of the countersink bit, but I suppose you could buy a tiny collar for the countersink bit. I use masking tape, you do you. I bought version with a #10 countersink bit. I do not know if you can swap out with other sizes [#6 or #8 countersink bits], but it looks like there is room in the body of the for longer/thinner sizes.

Good product

These work in the beginning BUT the unit fails after a short time; it is not for the commercial contractor... Please help me fix these things....i have 5 of them and they all lose their ability to properly "seat" the drill/bit. In other words, if you are on a ladder, and you pull the unit out of the hole, guaranteed the bit will fall out of its holder and fall to the ground. WTF...why hasn't Dewalt come up with a fix??? these things are great until they suck !

Lasted one project then the shank gets stuck on the drive side and won’t lock in on the drill side. The material wears out in short time and the tool becomes a hassle to use. Would be great if lasted. This happened to 2 different units.

The screw that holds the bit and counter sink is constantly loosening no matter how tightly it is screwed down. The other components have two screws on either side and do not loosen. Since the hex wrench is not part of the flip bit as it is with other brands, it requires hunting down an allen wrench every few minutes. Another complaint I have is that the release requires holding a the flip bit and pushing the collar up to get it on. Most flip bits attach by pushing the bit in the housing which is easily done with one hand. This is the worst dewalt product I have ever used. And I have two of them and have the same issues with both.

Quality feels lacking. If feels and sounds like cheap plastic. The versatility is great. The two stars was for the fitting to to tool. Almost all DRILL bits/attachments have smooth shanks, unless it is made for an IMPACT driver. Some DIYers arent familiar with the difference. I know the difference and I assumed the hex shaft was compatible with the Impact driver and it IS NOT COMPATIBLE. There for I am unable to use it for my IMPACT DRIVER and is ultimately useless unless I buy an actual drill or file it down smaller to make it fit (NOT RECOMMENDED)

Broken - drill wont switch sides. I had to use a plier to take it out and now its broken altogether after 1 year of occasional use

buon mandrino

Es excelente, de muy buena calidad y muy útil en carpinteria. Bueno, es marca DEWALT, SIEMPRE LO MEJOR DE LO MEJOR

Poor quality, badly machined, Had 1 before, no comparison, bad copy. Would not purchase again. Disappointed with Amazon