FLD Tachometer Hour Meter Motorcycle ATV Snowmobile Boat Stroke Gas Engine Generator Used on 2 Stroke Gasoline Engine (BLACK)

Description

TACH/HOUR METER for motorcycle, ATV, snowmobile, boat, generator FEATURES: Indicates operation in RPMs and hours Easy Installation no power or ground required No Battery Required-connects to spark plug wire Works on any gasoline engine Functions: Tach/Hour meter -Shows RPM's when the Engine is running When the engine is off, the meter shows total hours accumulated Installing Method: 1. Wrap the included pick-up wire around the spark plug wire five times Start wrapping the pick-up wire about 4cm from the end of spark plug boot Use the included zip tie to secure the pick-up wire wrapping as shown in the photo right 2. Before continuing the installation, insert the pick-up wire into the rear of the meter Start the motor to make sure the meter is picking up the ignition signal If it is, The LCD will Show RPM's when the engine is running When the engine is off, the meter shows total hours accumulated You'll have to wait at least 6 minutes for the timer to increment the timer display(1/10th of an hour) If it is not picking up the ignition signal, slide the pick-up wrap closer to the spark plug boot 3. If the meter is successfully picking up the spark signal, run and zip tie the pick-up along one of the throttle cables Make sure the pick-up wire can not make contact with the engine Also, make sure you leave enough slack (about 8 cm) so removing the sparkplug wire is possible Securing Method: a. Drilling into your frame with 2.5mm socket, then segue it to the frame coming with two pick-up screws b. Using padded double-sided tape on the backside of the meter and secured it to the frame spar with zip ties