Aintier 2Pcs Aluminum Cross Bar Roof Rack Roof for Toyota Tacoma Double Cab 2005-2021Top Rail Rack Crossbar Luggage Cargo Carrier Roof Rack Set

As others may have stated, the bolt holes don’t line up on the first attempt. I’ve found that you need to bend the front brackets to get the holes to line up by process of trial and error. Take it slow and just start the bolts in the rear with a couple turns, then push and pull the rack to fit the middle bolts. Finally push up under the front and bend to adjust the brackets the best you can. Eventually it’ll come together. But yes, it’s clear not a lot of care was taken in the design and fit of this aftermarket rack.

The trim around the actual roof rack is loose and the brackets them at screw it into place came bent. Some maneuvering got it as close as I could. Roof rack looks fine but doesn’t sit completely flat to the roof no matter the adjustment. Unsure how much better an OEM would sit on the roof but I would take a gander at other Tacoma’s with this similar roof rack and check out how well it sits on the roof.

Item arrived quickly. The plastic parts seem like they could be more robust- I'm not confident of the load rating. Some short screws were longer than other short screws, so that had me guessing a bit. Make sure to remove the crossbar to facilitate installation, and don't tighten everything up until all screws have been started. Some didn't line up perfectly-one of Murphy's Laws- interchangeable parts don't. The seal that lies on the truck roof doesn't completely seal- had a gap on the driver's side inboard (my friend's OEM rack had the same issue). BUT- overall- it looks pretty good, and if it'll haul my kayak then mission accomplished.

They looks real good! I did have to adjust the brackets to get all the screws to line up and the 3m tape on the back does not stick well. For the price not to bad, but you get what you pay for

Exactly what I wanted. They fold up when not in use. They look cool. If you know the difference between an alan key and a flathead screwdriver, you can handle this.

One bracket bend and after install front side rack is little lift

Not much instructions and the screws didn't line up like they should have. It looks just like the actual Toyota brand.

On time and looked good